Jump to content

Edge Brakes


Recommended Posts

I got my Edge AWD last May and I have got a very soft brake pedal, so much so that sometimes I need to pump to get a solid feel again. The dealer flushed the fluid once and it was cured but it has now returned. My neighbor who got his at the same time has never had this issue. Do of any of you experience this?

 

Buzz

Link to comment
Share on other sites

No I don't have this issue, but it sounds to me that you have a leak somewhere and the Brake system is drawing air into it. A soft Brake issue is normally related to Air entrainment. Even moisture will still compress although moisture will cause other problems, but not usually a soft pedal.

 

You say the dealer flushed the system once and it was better, but has now returned. I would ask them to bleed the brakes and watch them do so. If they find air in the system then make certain they check everything for tightness and any sign of a leak. If this cures the problem, if only temporarily then you know you are getting air in the system.

 

Your dealer will jump all over that issue PDQ. In the unfortunate case that you would have an accident that dealer and Ford would be called Respondent!!!

Link to comment
Share on other sites

I got my Edge AWD last May and I have got a very soft brake pedal, so much so that sometimes I need to pump to get a solid feel again. The dealer flushed the fluid once and it was cured but it has now returned. My neighbor who got his at the same time has never had this issue. Do of any of you experience this?

 

Buzz

Got AWD 08 very mushy brake pedal, just starting to deal with this problem Wish me luck.

Link to comment
Share on other sites

The pedal has always felt soft which i believe is part of the reason that the brakes were so heavily criticized by the media when the Edge was in pre-production. Although they feel a lot softer and travel more than some cars i have driven, they still seem to stop very quickly!

Link to comment
Share on other sites

The pedal has always felt soft which i believe is part of the reason that the brakes were so heavily criticized by the media when the Edge was in pre-production. Although they feel a lot softer and travel more than some cars i have driven, they still seem to stop very quickly!

 

Ford brakes have done that for a long time including my 2000 Lincoln LS. Doesn't affect the stopping power - it just feels spongy. Must be something in the master cylinder design or materials.

Link to comment
Share on other sites

Ford brakes have done that for a long time including my 2000 Lincoln LS. Doesn't affect the stopping power - it just feels spongy. Must be something in the master cylinder design or materials.

It is either air entering the system, due to porous flex hoses (not very likely) or a soft mounting, using thin flexible metal, of the master cylinder.

VW had this problem with their type 4 back in the 70s...This entire car was a problem( 4 year production run)...

But the Lincoln LS is different than an Edge- the same design, using thin metal, is not likely...

Maybe this is a quirky master cylinder design ???

Link to comment
Share on other sites

We purchased a Edge in November, It is great until my wife wrecked it, She went to apply brake and she says the brakes went soft and did not perform. She justed a curb hit a road sign and did alot of damage to the vehicle.

We took it to the repair shop and will be getting it back this week. It will go to FORD to see what they think.

Has anyone else seen similar issues to this degree?

KB

Link to comment
Share on other sites

The pedal has always felt soft which i believe is part of the reason that the brakes were so heavily criticized by the media when the Edge was in pre-production. Although they feel a lot softer and travel more than some cars i have driven, they still seem to stop very quickly!

 

 

Stole the words out of my mouth.... :) You get used to it. Still think they need to dial in a touch more rear bias personally.

Link to comment
Share on other sites

  • 3 weeks later...
We purchased a Edge in November, It is great until my wife wrecked it, She went to apply brake and she says the brakes went soft and did not perform. She justed a curb hit a road sign and did alot of damage to the vehicle.

We took it to the repair shop and will be getting it back this week. It will go to FORD to see what they think.

Has anyone else seen similar issues to this degree?

KB

That I think is a problem - more so than the spongy brakes.

 

I agree the brakes are spongy but have not had time to look in depth at them - heck - we have had the car for 2 days and one of those days was the superbowl.

 

I had a Ford Contour that was spongy too. Replaced the flexible lines with SS ones and it helped a lot imo - semi easy to do - but not for faint of heart since brake are very important. During the upgrade, flushed and replaced the fluid - night and day. On my Mazda 3, I still do have the stock flexible lines and no spongy feeling.

 

Just my thoughts

 

Solas

Link to comment
Share on other sites

For less than $150 you can have a set of braided stainless steel lines made up for your Edge. They provide a great improvement on the rubber hoses which stretch under the hydraulic pressure of heavy braking.

 

I have those on my race car, along with a pretty incredible brake system. I have considered flushing the system myself and using the same Motul brake fluid I race with but through time I have found the problem to be intermittent on my Edge, which is frustrating and hard to pin point the cause.

 

Thanks for the feedback. Other than this issue, it has been a fine vehicle.

 

Buzz928

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...