Jump to content

Recommended Posts

The cup holders are illuminted only as part of the ambient lighting package (front and back of cup holder closest to center console and rear of cup holder closest to radio).

 

On the shift selector panel, to the left of selector knob, they are all illuminated the same blue/white color and they do not change color nor indicate which gear you are in. That is only indicated on instrument panel, above the steering wheel.

Link to comment
Share on other sites

Sorry... had to ask. It's like when you call any computer support line and they ask you to reboot it.

 

It may be as simple as jmr said, someone opened the console and never plugged the lights back in.

 

Very easy to remove lower console. Just need socket wrench (10mm I think) and a torx bit).

Link to comment
Share on other sites

So I got one problem solved. The light that clips into the plastic for the gear lighting had broken off from the previous owner. I managed to secure it back in place, but I cant figure out the cup holder lighting issue. Everything seemed to be plugged in as it should. Didnt notice any broken wires in that part of the harness. Not sure what the next step is other than testing that the wires have power.

 

I did notice some cut wires towards the bottom of the console. Any idea what these go to?

post-47003-0-23421400-1510015719_thumb.jpeg

post-47003-0-41543500-1510015731_thumb.jpeg

post-47003-0-70348200-1510015752_thumb.jpeg

post-47003-0-53203100-1510015785_thumb.jpeg

post-47003-0-75028400-1510015811_thumb.jpeg

post-47003-0-53707000-1510015824_thumb.jpeg

post-47003-0-97502800-1510015857_thumb.jpeg

  • Like 1
Link to comment
Share on other sites

That response deserved a spoiler alert!

 

Clearly, the old owner didn't like the cup holder LED's.

 

Just FYI, there's only two led modules (as indicated in the diagram). One for the rear of the back cup holder and another that illuminates both the front of the back cup holder and rear of the front cup holder.

  • Like 1
Link to comment
Share on other sites

I traced the wires from the back cup holder to the front one, then to the map pocket led. But I stopped once I got to the cut wires and started trying to figure out where they were supposed to go. I really shouldve traced them back from where they were cut. I can do that today probably.

 

So, I noticed from the diagram above that theres supposed to be an led for the map pocket. I assume thats the little open area in the center console towards the bottom/back kind of near the passengers side cigarette outlet? I looked back there to verify there was an led there and guess what, that one also doesnt work.

 

Im assuming theyre related. The light inside of the center console/storage area works.

Link to comment
Share on other sites

Here's the location for the LEDs for ambient lighting:

 

· Cupholders (located in the center console)
· Storage compartment(s)/map pocket (located in the center console)
· Front footwells (located under the instrument panel)
· Rear footwells (located in the rear of the center console)
· Inside pull handles (located in each door trim panel)
· Door map pockets (located in each door trim panel)

 

The LED you're referring to is inside the center console itself. There isn't an LED below the radio/under the center cluster panel in front of the center console.

 

I will say that that area (which has a rubberized pad) is a very strange area. I haven't used it in over 5 years!

 

It would appear as though the cut wires are for your cupholder LED lights.

  • Like 1
Link to comment
Share on other sites

  • 3 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...