Jump to content

Search the Community

Showing results for tags 'front turn signals'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Ford Edge Forum
    • Welcome Forum!
    • Forum Help & Site Suggestions
  • Ford Edge Social Forum
    • Lounge
    • Articles, News & Reviews
    • Buying, Leasing & Ordering
    • Dealership & Vendor Experiences
    • Competing Crossovers & Vehicles
    • Facebook Pages
    • Multimedia
    • Owner Impressions
    • Super News Ticker
  • Ford Edge Lincoln MKX Modification and Technical Discussion
    • Accessories & Modifications
    • Ford Edge & MKX Member Builds
    • Alarms, Keyless Entry, Locks & Remote Start
    • Appearance - Detailing, Wash & Wax
    • Audio, Backup, Navigation & SYNC
    • Brakes, Chassis & Suspension
    • Cargo, Hauling, Roof Racks & Towing
    • Exterior & Body
    • Glass, Lenses, Lighting, Mirrors, Sunroof (BAMR), Wipers
    • Interior, A.C., Heat, Interior Trim
    • Recalls, TSBs & Warranty
    • Wheels & Tires
    • Ford Sync Specific Forum
  • Ford Edge & Lincoln MKX: Powertrain
    • 3.5L and 3.7L
    • EcoBoost
    • Edge RS
    • Edge ST
    • All Wheel Drive (AWD)
    • Transaxle (FWD)
  • Ford Edge, MKX Nautilus Model Year Specific
    • 2015+ Edge & MKX Generation II
    • 2007-2014 Edge & MKX Generation I
  • Classifieds
    • Classifieds
  • Test Forum
  • Ford Edge & Lincoln MKX: Interior
  • Ford Edge & Lincoln MKX: Recalls, TSBs & Warranty

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start



Found 1 result

  1. I've purchased the HP24 switchbacks from my front turn signals from Diode Dynamics. Before ordering, I asked them how many "sets" of 2 resistors I needed for the install and they advised 1 "set" which is what i ordered. Upon receiving the bulbs and the resistors, I went to their website and viewed the installation video which showed them installing resistors on both the hot wire AND the ground. I emailed them and asked them about this and, in all honesty, their response was rather cryptic. I asked for clarification by asking very specific and directive questions and their response did not answer my question. As such, I'm going to toss it out here. For each signal, there are 3 wires - 1 ground and 2 hot (due to the bulbs being dual filament). Therefore, there are 6 wires at play (3 for each signal) yet I only have 2 resistors to install, In order to eliminate hyper flickering which 2 wires to I need to install the resistors on with the attached wire taps? Thanks in advance for the clarification !!!