Jump to content

BCM


Cccccc

Recommended Posts

If it works like SJB replacement, an appropriate scan tool (VCM/IDS compatible) is needed to upload the BCM configuration from the old unit and download into the new BCM.

 

EDIT: If you don't download the config, you will need to get the AS-BUILT DATA from Ford's data center and download into the new module.

Programmable Module Installation (PMI) Using the Integrated Diagnostic System (IDS) When the Original Module is NOT Available

NOTE: Following module installation, some modules require a separate learning procedure be carried out. For adaptive learning and calibration instructions, refer to the specific module removal and installation procedures.

  1. Install the new module.
  1. Connect the IDS and identify the vehicle as normal.
  1. From the Toolbox icon, select Module Programming and press the check mark.
  1. Select Programmable Module Installation.
  1. Select the module that was replaced.
  1. Follow the on-screen instructions, turn the ignition key to the OFF position, and press the check mark.
  1. Follow the on-screen instructions, turn the ignition key to the ON position, and press the check mark.
  1. If the data is not available, the IDS displays a screen stating to contact the As-Built Data Center. Retrieve the data from the technician service publication website at this time and press the check mark.
  1. Enter the module data and press the check mark.
  1. The IDS downloads the data into the new module and displays Module Configuration Complete.
  1. Test module for correct operation.
Edited by WWWPerfA_ZN0W
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...