Jump to content
Sign in to follow this  
lagunarads

2008 Edge passenger fender replacement

Recommended Posts

I purchased a replacement fender and wonder how hard it is to remove the damaged one and install the new one. Looks like there are not too many mounting points, with possible one or two that attached to the bumper. Anything else I need to look out for?

Edited by lagunarads

Share this post


Link to post
Share on other sites

If there is no other damage to the vehicle, trial-fit the replacement fender, after that remove it and have it painted separately.  Then re-install it back on the car and be done with it. :thumbsup:

 

good luck,

 

Claude.

 

P.S: Sorry, I don't know about the mounting points...

Share this post


Link to post
Share on other sites

Is this what you're looking for?

(If you run your curser over the images, you can read the titles, i.e. no 1.jpg, no 2.jpg, etc.)

 

Fender 


Removal and Installation 

 

1.Remove the 2 screws and the rocker panel moulding end cap. 

{image 1}

 

2. Remove the front fender splash shield. For additional information, refer to Fender Splash Shield in this section. 

 

3. Remove the lower fender bolt. To install, tighten to 9 Nm (80 lb-in). 

{image 3}

 

4. Remove the nut from the stud inside the fender well. To install, tighten to 9 Nm (80 lb-in). 

{image 4}

 

5. NOTICE: The front bumper cover may be damaged if pulled outward too far while trying to access the bolts. 

Remove the front fender bolts. 
Remove the front bumper cover corner. 
Remove the bolts. 

To install, tighten to 9 Nm (80 lb-in). 

{image 5}

 

6. Remove the upper rear fender bolt cover. 

{image 6}

 

7. Remove the upper rear fender bolt. 
To install, tighten to 9 Nm (80 lb-in). 

{image 7}

 

8. Remove the 2 upper fender bolts. 
To install, tighten to 9 Nm (80 lb-in). 

{image 8}

 

9. Remove the fender cowl bolt. 
Position the cowl cover aside. 
Remove the bolt. 
To install, tighten to 9 Nm (80 lb-in). 

{image 9}

 

10. Remove the front fender. 

 

11. To install, reverse the removal procedure. 
If necessary, transfer parts.

no 1.jpg

no 3.jpg

no 4.jpg

no 5.jpg

no 6.jpg

no 7.jpg

no 8.jpg

no 9.jpg

Edited by enigma-2
Add note on image title
  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×