mironc

The little trim can be easely remove but the longer one can't be. It's hold in place by plastic rivets. Mine had little scratches so I decide to wrap them.

www.tdotperformance.ca was the better price I found for my K&N cold air intake. Its sound loud but great!

Hey Thank you! I did the sme job on my Edge as describe in you instructions.

So I installed them tonight and pretty much had to make my own holes for everything but I think it they came out looking nice. Might have to get a set for the rear now just but I'll have to wait and see how it look out of the garage and in day light tomorrow. It's supposed to rain tomorrow so I should be able to see if they actually prevent all that water and dirt from getting on the rocker panel inside the door frame.

 

Without further ado here are some pictures, any questions feel free to ask. Used my iPhone for pics so I apologize for quality and darkness of some.

 

Started by using the R hole, but that put them a little low so I drilled another hole about a half inch below it.

 

then I had to modify the splash guard a bit by cutting it as you can see

 

this is where I drilled another hole for the other stock screw

 

drilled another hole to add another screw just to keep it secure

 

here you can see where I added that.