tpettigr

I changed the spark plugs in my edge today and this post was very helpful. It didn't take long at all after I had waited for the vehicle to cool down (it was still slightly warm). I was nervous about using too much force to remove the old plugs but they actually came out pretty easy. I have a 2012 SEL and it has almost 110,000 miles on. Some of the plugs had some fouling but it wasn't too bad. I checked Autozone and O'Reilly's and neither had the Motocraft Plugs in stock so I used the NGK Iridium plugs. Everyone says that the plugs are gapped correctly in the box but that's not the case so make sure that the gap is correct. After I finished I started and ran the vehicle for about 10 minutes. I drove it a short time later and I it seems to run better than before but that could just be all in my mind.

Hello everyone,

This is my first post to the forum but I've looked through alot of threads. I just installed LED bulbs in my front turn signals, rear turn signals, tail lights, brake lights, back up lights, tag lights, and interior lights. I used Pilot brand LED bulbs that I bought from Walmart. This bulbs are CAN Bus bulbs. I did not have any bulb out indications and the bulbs did not cause any hyperflashing. I did not have to use any load resistors. I am very pleased with the look and brightness of these bulbs. I had to use 3157 for the turn signals even though they call for 3457 or 3757 but I don't see any issues with using the 3157's instead.

The only issue I ran into was with the rear cargo lamp. The festoon style bulbs fit a little loosely causing them to flicker or go off so it just took a pair of needle nose pliers and squeezed the clips closer together so the bulbs fit a little tighter. They work fine now.