ash042679

thanks so much.

I will start with the blend door motor located by the glove box , it seems easily accessible.

I believe there are few more other than this one, but hopefully this is the one.

is there also one on the drivers side ?

will keep everyone updated

here is the photo

enigma - 2

I ran the test you mentioned.

looks like I have an error code

A2 6E

those were the results.

anywhere I can find what these codes mean?

I will run that test.

I will also review the fuses. I will try to find a diagram online for the fuses relates to the hvac. not sure where I placed the manual for the edge. thanks in advance

any chance it could be the actuators? looks like there may be a few of them in the system

I was using the OBDLink MX , didn't show any codes.

Haven't tinkered with it just yet, but just noticed it won't switch to any other settings. Whether I want floor only, or whatever other setting it is just stuck on the combination of floor and main vents ...

Frustrating , considering the temp controls work ....

More worried in the winter when I need the windshield defrosted than I am now

Thanks I will review ; ran a diagnostic wit my OBD 2 tool not showing any error codes ; I will review the document.

One more thing I noticed , both on the control unit that was in the car and the second one I put it , once I hit the front defroster button , the small light on the control unit turned on, and no matter what other button I would hit , that windshield defroster light stayed on ...

Maybe I should try to leave the battery disconnected for a while

I did actually ; didn't have any luck ... should I leave it disconnected for a while so everything resets?

Good Evening All,

I have a 2008 Ford Edge , Dual Climate Control ... Here's my issue -

I am able to change temperature up and down, works flawlessly ... The problem is that the air is stuck flowing thru the front vents and floor, it will not change. I have tried to set onto the windshield it won't work , tried to set to just the floor and it still blows thru the front vents and floor, its essentially stuck in that position.

I originally thought it may have been the control unit , ran up to the car yard and grabbed another unit, installed and same issues .

I am somewhat perplexed. As mentioned, I can adjust the temp settings , but the flow of air is stuck...

any thoughts? possibly the actuators?

any insight would be greatly appreciated.