Aodiaka

Hi,

Please can someone help me with the expected resistance from camshaft and crankshaft position sensors.

Austin

How many miles on your Edge?

 

What oil are you using? Brand, weight, etc. What filter? Any leaks from the engine oil pressure switch area (just above the A/C compressor, to the left of the oil filter)? Not really consistent with oil sometime Mobil 1.

 

 

The P0019 error code is most likely caused by failing VCT solenoid(s) or other timing components. Have you had any issues with starting the Edge? Like an extended crank for instance. Yes experiencing extended crank.

 

May just need spark plugs and PCV valve to fix the misfires, especially if the plugs are fouled from poor fuel. Change the air filter, clean the MAF sensor (with MAF or electrical parts cleaner) and clean the throttle body. Check the PCM coil driver resistance to rule out PCM errors.

 

The oil warning light can come on for numerous reasons. It could be the PCM software needs updating. Or the engine has stalled/is about to stall then restarts. Or you have just cold started your engine. If the warning light STAYS on, then the software update might be necessary OR there is real hardware failure.

How many miles on your Edge?

 

What oil are you using? Brand, weight, etc. What filter? Any leaks from the engine oil pressure switch area (just above the A/C compressor, to the left of the oil filter)? Not really consistent with oil sometime Mobil 1.

 

 

The P0019 error code is most likely caused by failing VCT solenoid(s) or other timing components. Have you had any issues with starting the Edge? Like an extended crank for instance. Yes experiencing extended crank.

 

May just need spark plugs and PCV valve to fix the misfires, especially if the plugs are fouled from poor fuel. Change the air filter, clean the MAF sensor (with MAF or electrical parts cleaner) and clean the throttle body. Check the PCM coil driver resistance to rule out PCM errors.

 

The oil warning light can come on for numerous reasons. It could be the PCM software needs updating. Or the engine has stalled/is about to stall then restarts. Or you have just cold started your engine. If the warning light STAYS on, then the software update might be necessary OR there is real hardware failure.

Few weeks back I started notice my ford edge 2011 SEL was jerking when not in motion sometimes the engine goes of on the dashboard you see low engine oil warning sign.

The fuel filter was seen clogged with dirt this was replaced but misfiring continues further check revealed P0019 crankshaft position - camshaft position correlation (bank 2 sensor for ford edge.

How do I proceed to fix it.