ToeNuttz

2 hours ago, WWWPerfA_ZN0W said:

Although not typical for a coolant related issue, have you been tracking coolant level in the reservoir/degas bottle?  If it has been steadily and appreciably declining, you could have a problem.

How many miles do you have on your 2017?

 

Fuel injectors should set P020x codes, but they typically come late in the day for GDI injectors.  I have seen many fail without an error code being set.  So is it possible?  Yes. If you change 1 injector, change them all.

I have not been tracking the coolant level. My Edge is just shy of 70K. Just like spark plugs, change one you change them all. I have not looked into the replacement of the injectors yet. What would this typically run as far as cost and time to do it myself?

2017 Edge Ti 2.0L shows P0304. The spark plugs were changed and I swapped ignition coil 4 to 1 spot. The code was cleared and 2 days later it popped up again, same code. Could my next target be my fuel injector?

On 9/29/2017 at 6:11 PM, enigma-2 said:

This the one I use with my Android.

 

ScanTool 426101 OBDLink MX Bluetooth: Professional OBD-II Scan Tool for Android & Windows https://www.amazon.com/dp/B006NZTZLQ/ref=cm_sw_r_cp_apa_GhTZzbR0P8B0F

 

Can't modify the car's internal settings (need laptop for that), but you can monitor hundreds of values.

You need this OBDII adapter to make any changes.

https://www.amazon.com/stores/OBDLink/page/6AB05129-8520-4122-BBD6-31712037F639?ref_=ast_bln

Any recommendations on an OBD2 adapter?

I recently found out I can open my windows on my 2017 Edge Titanium via remote. I am not able to remotely close them though. I have gone into vehicle settings - windows and it only show the option to turn on and off the open windows. It does not show the close option. Is there a way to add this to the vehicle? Is it just taking it to the dealer and asking for the program/hardware (if any) to be installed.

4 hours ago, papinist said:

What type of fuses are used in the internal compartment? I'm looking to buy fuse tap harness but don't know the fuse size ? 

https://www.amazon.com/gp/aw/d/B072J3L2JN?psc=1&ref=ppx_pop_mob_b_asin_image

Unfortunately, I don't have any alligator clips.  I tapped in to the yellow positive and the black negative. Now I'm just waiting to see how long before it turns off.

-edit-

It's been on for over 5 minutes now. I think the yellow might be the constant. 

Anyone able to tell me ignition wire and ground. My probe is to fat to test. No pun intended.

8 hours ago, enigma-2 said:

Easiest and cheapest way is to use a pre-made harness (mirror-tap) that plugs into the back of your mirror connector. The mirror is on the time delay circuit, it powers on with the ignition and stays on until a door is opened or timed expires (just like the radio.)

 

SimpleUSBCable 12V to MicroUSB Two-Prong Universal Dashcam Adapter https://www.amazon.com/dp/B07BFRWC3X/ref=cm_sw_r_cp_apa_i_YhefDbNKWS2FZ

That looks like it will do perfectly. Thanks for the link!

.

Getting to the fuses just left of the drivers panel looks like a pain in the you know what. Maybe I should hardwire it instead to the cigarette plug. I do have a NUNET Hardwire Kit. It come with a fuse on the wire harness as well.

I would like to know my options for hardwiring a Dash cam instead of using the cigarette plug in. What location is this on the fuse panel? What fuse is it? Would also like to know if wiring this to the USB fuse is a good or bad idea as it will always be "on".

I paid the $8 and not only did it let me download the window sticker it also showed me information on the warranty and recall information that was already completed on my vehicle. Well worth the money.

Thank you PerfA. I didn't think about that.

My Edge was bought as a used vehicle not at a Ford dealership.  Is there a thread in this forum that will point me to the features my vehicle has?