TMac1795

Reseated the pressure sensor switch; should I replace with a new one? Only pics I have are of an oil return line ( assuming). 
where would I find the so called weeping turbo hose? 

Have an annoying oil leak on my 2015 edge 2..0 . I have changed the oil filter housing gasket and the vaccum pump gasket on top by the valve cover . Still leaking. Looks to be at front of engine as the larger hose at the bottom is wet. Any suggestions on what to try next. 
Many thanks 

On 10/26/2019 at 10:30 AM, rhynerj said:

So Since I got no responses to this, I figured that there were no others with the same issue.  But I did end up fixing the problem today. 

ordered the new HVAC mode motor from Ford,  When you order from the website they have a nice picture where this particular motor is located. 

Drivers side top motor.  To access it you need to remove the front lower dash panel under the steering column.  Take out the two screws (7mm) holding in the panel at the left side coin drawer. Gently unsnap the lower dash from its holders.  You don't need to remove the screws holding the inner dash. Take the lower steering column cover off.  Then you can see the motor.  the motor is held in with two philips head screws, it is easier to remove if you move the scan port out of the way two 8mm nuts... When you go to put in the new motor, it probably isn't set to the position where the old one is.  To solve this plug in the motor and turn the accessories on in the car. Put the heater on auto and the motor should adjust properly.  Reinstallation is the reverse of the way you took it apart.  Only took me 1 and 3/4 hours to do the whole thing and I did some extra steps that weren't needed...  Good luck. 

This sounds like the issue I'm having on my 2015 as well. Do you happen to have a part # that you could share? 

Cheers

Do you mean just the A/C button, not the power button? Should the hvac unit be off or on? 

I'm sort of having that issue with my 2015 titanium. Air blows from defrost and floor only. The temperature works no prob ( hot and cold when needed). I have changed the blend door actuator on the drivers side and still nothing. Any suggestions are greatly appreciated