Just want to reinforce a point that's been made. I just installed the Scion protector on my 2011 LTD. Initially, I followed the mfg directions and worked from the middle. This caused gapping on the corners of the wrap-around edge. I pulled the whole thing up (most of the tape was still intact) and worked the opposite direction, ie, from wrap-around edge towards the rear of the bumper. The fit was perfect. I had previously notched the back edge of the protector to account for the 4 center-most trim screws that attach the bumper cover to car. If you work from front to back, you definately need to notch where the screws are because they will be completely hidden by the protector. If this were a virgin install instead of a retry, I'd suggest that you run the middle and rear tape backings (red) out the back rather than front edge of the protector. When you strip the red backings off the tape, do so at an extreme angle or the backings will tear. Great fit on the second try, looks like it belongs on the car and the wrap-around edge will definitely save some wear and tear.