Jump to content

APL111

Edge Member
  • Posts

    6
  • Joined

  • Last visited

About APL111

APL111's Achievements

Newbie

Newbie (1/14)

1

Community Answers

  1. Well I pulled fuse 15 disabelling the abs and its gone. I am positive the abs is cycling and its not a rotor. It started this 2 days ago. Sometimes it does it sometimes it feels normal.
  2. Hello again Seems my wifes car has a mind of its own. First off their are no idiot lights on dashboard abs lights off. The problem is the abs will kick in when their is no need for it. The abs is pulsing the brakes yet it does not show the abs engaged on dashboard, maybe that is not lit when abs is engaged. The drivers front cv axles going to be replaced its boot is torn. Since the abs light/cel lights off I cant pull codes. I am thinking grease from axle got on rotor and contaminated brake pads. Or a wheel speed sensor is dirty. I tried cleaning off the entire area with brake cleaner and no luck.. Thing is sometimes it brakes fine other times it seems the ABS has a mind of its own. I am confused as I cant pull any codes or they are not visible. The Edge has 120,xxx miles on it. Thank you. Tony
  3. So basically it pulls straight out and you line up the opening and push it in?
  4. Sorry I meant how do i get the axle to slide out of the PTU? What is holding it in place?
  5. Hello I need to replace the cv axle on the drivers side on my 08 edge awd. I have never done this but I am proficient with working on cars. I have the shop manual and have looked at youtube videos but cannot figure it out. On the side that goes towards the PTU there is clip on the splined shaft how does one remove this to get the unit out. I know the other end is held by the hub bearing. Thanks alot for the help. Tony
  6. Hello My name is Tony. My wifes car is the 2008 ford edge awd.
×
×
  • Create New...