

Chigozie
Edge Member-
Content Count
8 -
Joined
-
Last visited
About Chigozie

-
Rank
New Member
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
Chigozie started following ABS, traction and wrench light signal on dashboard, Hot engine compartment, Hot engine compartment and and 1 other
-
I use an 07 ford edge, I noticed engine compartment always hotter than normal if I drive. Diagnosed with my scanner and no error message on engine except bad O2 sensors and temperature guage does not rise above normal .
-
I use an 07 ford edge, I noticed engine compartment always hotter than normal if I drive. Diagnosed with my scanner and no error message on engine except bad O2 sensors and temperature guage does not rise above normal .
-
Power steering issues. Hard to turn
Chigozie replied to Chigozie's topic in Brakes, Chassis & Suspension
I checked the rpm today. I was in a park position and raised the rpm while I turned left to right. it was very free. Another part dealer asked me to buy another pump. -
Power steering issues. Hard to turn
Chigozie replied to Chigozie's topic in Brakes, Chassis & Suspension
it's a 2007 edge. the fluid level is not full. I will have to check my oil dealer if he has valvoline Maxlife. It is hard on both right and left -
Good day house I replaced my power steering pump and I had to work on my steering rack to stop oil leaks. I use Mecron V as indicated on my manual, still my steering gets hard to turn. it's only free if I have parked the vehicle for some hours, after a while driving it becomes hard to turn.
-
ABS, traction and wrench light signal on dashboard
Chigozie replied to Chigozie's topic in Ford Edge & MKX Member Builds
yea you are right. it's the rubber boot I replaced on the CV axle. in Nigeria we are prone with water logged roads and this parts seem to wear off easily. I replaced the rubber boot and the light came on. though I have used it that way for over 2 months. thanks paulschott. I will take your response to my technician -
ABS, traction and wrench light signal on dashboard
Chigozie posted a topic in Ford Edge & MKX Member Builds
Hello house, I took my 07 ford edge to a technician to replace the rubber on my camshaft. After the repair I noticed ABS, traction and wrench light showing on the dashboard. We checked the ABS sensor and it is intact. Could this be a wrong setting on the tone ring? -
Hello house, I took my 07 ford edge to a technician to replace the rubber on my camshaft. After the repair I noticed ABS, traction and wrench light showing on the dashboard. We checked the ABS sensor and it is intact. Could this be a wrong setting on the tone ring?