Mikejohnson

Ok, so resistance in the injector is at 11 ohms with all 3 in the front. Voltage with accessory on shows 2.48 volts at all 3 injectors. Actually, update... If I check the voltage at start using the ground in the harness, it is reading 9.5 volts at all 3 injectors.

I actually did check the injectors. Even swapped 4 and 5 around with the same issue. There is no voltage going to the injector of #4. And it is a 3.5 engine.8

I have a 2013 Edge. The PCM was not sending pulses to the #4 coil. I replaced the PCM and it ran great for a few weeks. Now it is throwing the code for #4 cylinder again. Checked and the coil is getting signal properly. Checked the injector and it is not. Checked wire continuity from PCM to injector and it is fine. Would the PCM go out again, and for the same cylinder? What else could it be?