TurkF26
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by TurkF26
-
-
Did you get this resolved? You’ll always get an oil light when the motor dies like that. Could be a mechanical failure all the way to a PCM failure. Interested to know if you got this resolved
-
Have you turned the wiper on and used a DVOM to see if you’re getting voltage? If you are also check your ground connections in the gate / rear of vehicle. If one came loose or is dirty you’ll get random things that work erratically or not at all.
i can pull a Ford OEM wiring diagram if you need it. Could also be the start of a BCM failure but not likely.
I would check voltage and grounds before going any further. Could have a pinched wire somewhere, etc..
-
2fast4u is right. I work at a lot of bodyshops and Ford didn’t start putting belly pans / under shields really until 2014 and up on most models. My 2012 doesn’t have any belly pans either.
-
Mine too about 30 minutes. Just did it while driving on a road trip. Just don’t turn the ignition off while the update is processing. I’ve done a lot of these updates to ford vehicles and have seen them mess up APIM’s and such. Shouldn’t have an issue as long as you keep the car running / battery voltage about 12 volts
-
Mine did the same thing randomly. I found a tsb for a PCM update. Mine did it when I shifted randomly. I’ll pull the tsb and post it in the morning for you. Haven’t had a problem since I updated my PCM with my ford scanner. Unfortunately you’ll need access to a scanner that can program. It will also make you redo the PATS key (anti theft) so you’ll have to have all your keys with you.
i know ford dealers charge a lot sometimes at least here in California. Maybe they can help you out since it’s a TSB and known problem?
let me know if you want the TSB info.
sorry just noticed this was a post from 2018. My bad
2013 Edge rear wiper not working
in 2013 Edge & MKX
Posted
The ground is usually on the rear body panel or inner quarter panels behind all the trim.
bcm would require programming with a Ford tool or a scan tool that can do programming and I can give you the programming as built codes for it.
i would check your grounds though first. You’d have to remove all the rear cargo trim and it’s usually a single ground for everything back there.
I’ll look up the diagram and post it for you