Jump to content

securinu

Edge Member
  • Posts

    290
  • Joined

  • Last visited

  • Days Won

    4

Posts posted by securinu

  1. yes this is what you need . we do these all the time for the dealers and we stock them

     

    http://www.peripheralelectronics.com/

     

    select your car then scroll down to fordah

     

    The FORDAH is an essential installation accessory for select 2005-Up Ford/Lincoln/Mercury vehicles with MSCAN Data bus radios. Using this interface will enable factory features such as rear seat entertainment (RSE), rear seat controls (RSC) and the premium amplified systems , and even THXII data controlled digital amplified systems when the original radio is removed. Other features include data bus driven retained accessory power (RAP), vehicle speed sensor (VSS), illumination, reverse output, parking brake outputs for an easy navigation or non-navigation radio installations. There’s also a 5 volt data controlled regulated amp turn on for factory installed subwoofers and other vehicle key features that would otherwise be lost. The FORDAH also works with Peripherals line of steering wheel control interfaces (PESW series) for most aftermarket radios. The PESW series line of interfaces will allow the SWC to control your aftermarket radio.

  2. thanks , yes a bit noiser but hey thats why i do car stereo right????

     

    Great handling tire, i had this little civic think he was going to get around me on a corner when his lane ended. These tires held the lane flawlessly, and his rear erector set wing did nothing to help him except to look stupid. I never understand those big cheese cutter wings on the rear of a front wheel drive car.

  3. So is there one for seatbelt reminder? I'm too lazy to look in the manual, and besides I have never looked at an owners manual in my life, why start now?

     

    Otherwise thanks for the slight help there...I did not realize thanks like seatbelt reminder, programming new remotes and what not where detailed in the manuals. *shrug*

     

     

    Why is it everyone elses resposibility to read the manual for you . I'm guessing your the one stuck someplace because you dont know how or where to do something simple to get back on the road.

  4. i had the same issue and the dealer replaced the seat under warranty. but i do a lot of work for this dealer so i get some things done that other might not get.

     

    1 RO had the following on it

     

    1) Driver seat replaced

    2) headliner replaced due to sagging and it still sags at the back of the rear BAMR openong.

    3) dash pulled to replace gasket under windshield

    4) battery replaced wont hold charge

    5) steering wheel controls replaced volume down wasnt working.

    6) front brakes replaced as they would make a grinding sound when applied 3-4 times after 4 or more hours sitting.

    7) center console lid replaced as it squeaked when you would have an arm on it while driving.

  5. TSB 07-16-11

     

    08/20/07

     

    ROOF OPENING PANEL SQUEAK/RATTLE

     

    FORD:

    2007 Edge

     

    LINCOLN:

    2007 MKX

     

    ISSUE

    Some 2007 Ford Edge and Lincoln MKX vehicles equipped with a roof opening panel may exhibit a rattle or squeak from the rear glass area. This may be caused by the delamination of the rear trim ring hook and loop (Velcro) adhesive. Inspect the rear trim ring and if loose, determine if the loop tape has delaminated from the plastic trim ring.

     

    ACTION

    Follow the Service Procedure steps to correct the condition.

     

    SERVICE PROCEDURE

     

    If delamination of the hook and loop has occurred, use the following procedure to correct the concern. If no delamination has occurred, follow normal Workshop Manual (WSM), Section 100-04 diagnostics.

     

    1. Remove rear trim ring per WSM, Section 501-17.

     

     

     

     

     

     

     

     

    2. Inspect all loop tape locations for delamination. (Figure 1)

     

     

     

     

     

     

     

     

    3. Remove all delaminated loop tape from module. (Figure 2)

     

     

     

     

     

     

     

     

    4. Clean trim ring attachment surface with a Isopropyl Alcohol or Rubbing Alcohol (IPA) wipe (Figure 3).

     

    5. Allow surface to dry.

     

     

     

     

     

     

     

     

     

     

     

     

    6. Apply Motorcraft® Instant Gel Adhesive to trim ring surface. (Figures 4 and 5)

     

     

     

     

     

     

     

     

    Apply loop pad to trim ring. (Figure 6)

     

    8. Allow adhesive to dry per Motorcraft® Instant Gel Adhesive recommendation.

     

    9. Reinstall trim ring to vehicle per WSM, Section 501-17.

     

    10. Clean roof opening panel glass with Motorcraft® Ultra Clear Spray Glass Cleaner or equivalent.

     

    WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage

    IMPORTANT : Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

     

     

     

     

     

     

     

    Parts Block

     

    OPERATION DESCRIPTION TIME

     

    071611A 2007 Edge/MKX With Roof 0.4 Hr.

    Opening Panel: Reapply

    Loop And Pad To Trim

    Ring, Includes Time To

    Remove And Install Trim

    Ring, Clean Glass

     

    DEALER CODING

    CONDITION

    BASIC PART NO. CODE

    7050036 24

  6. Just popped these in last week 7" TFT LCD Monitors W/ Tilt. Hooked them up to the Pioneer f900bt Rear monitor output . They come on automatically when signal is rec'd Have a 2nd A/V in and wireless headphones as well. We just got them in the store they are inexpensive and are almost a dead on match for color. They will have it with built in DVD in about a month there current one with dvd has a zippered cover. Overall very good quality. We have put about 20 sets at the local ford dealer they are selling pretty good so far.

    post-708-1253594780_thumb.jpg

×
×
  • Create New...