Jump to content

Sandy Mods 003


Bob C.

Side view after a set of H&R lowering springs were installed.

From the album:

Sandy

· 5 images
  • 5 images
  • 0 comments
  • 11 image comments

Photo Information

  • Taken with SONY DSC-S980
  • Focal Length 11.6 mm
  • Exposure Time 1/160
  • f Aperture f/7.3
  • ISO Speed 100

Recommended Comments

It seems to have settled down to its "normal" ride height. Its almost 2" lower than stock. Just as H&R described. Its definately firmer, but also a little supple over the small highway ripples. Make sense? Not sure if its the progressive wind in the springs or what. I like the look, but would kinda liked a little more drop in retrospect.(a full 2" or 2.25") I've got to get my set of 22's cleaned up(285/35-22 Toyo Proxes) and see how the final outcome is. But you have to remember, this is a short wheelbase truck. So normally the ride is like a Jeep Wrangler. It tend to buck or rock back and forth over some bumps. I really noticed it today. Here's what: you know when they open a road to put in a new pipe? After a few weeks the patch gets slightly depressed? Well, the truck goes "Thump-Thump" over these. I wonder if different struts would help? Our wives would probably object to our adolescent behavior! Bob

Link to comment

The kit from H&R did not come with, nor was there anything about camber plates/ bolts/ eccentrics in the kit. H&R said this was a direct bolt in. All I would have to do is a 4-wheel alignment afterwards. My shop that I used did the install for $500 and the alignment for $89. Which I thought was reasonable. Total time in the shop was just over 4 hours. I got estimates from 3 different shops before I had it done. They were $500 to $780 @ STS! Hope this helps. The main reason I did all this is because I'm an amputee and with the wide sills I was having a little difficulty getting in without banging my leg all over the bodywork. That 2" made just the right change for me. Good luck, Bob

Link to comment

Excellent looking SPORT!!! That color looks really good in the picture. The drop looks good to "tighten it up" You explained how it rides.. i find my Sport to ride pretty rough from stock but then again i've never had anything wearing 22 inch wheels!! How does it handle?

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...