CampIam

My two 911 emergency contacts were deleted during the update and I had go in and enter them again. All other program settings & radio stations stayed the same so I didn't think to check that feature until just last night while I was playing with some other settings. I don't know if anyone else noticed this after their updates however if you use that feature & haven't verified yours are still programmed best check.

Pretty much followed what others have done with leaving the chrome ring on. I popped off the leather strips on either side of the console carefully pulling from the front towards the seats, after that I partially popped off the larger black plastic pieces below where the leather pieces on both sides were just close to the small plastic piece that wraps around the back of the pass through storage so I could pop off that small piece from the bottom. I then rolled the bottom of that piece carefully towards the engine which allowed the top that has 2 plastic tabs that hook the back side of the pass through to unhook. That exposed the back of the USB module. Then from the passengers side I used a small plastic trim tool to press in the top tab of the USB module 1st, pushed the top of the USB module out, then used the same tool to press the bottom tab and it then completely came out. Reverse order to reassemble. All in this took me about 25 minutes from start to finish.

Thanks all for the info. I installed the new hub part #: HC3Z19A387B & software today with no problems. I don't recall seeing this previously in this thread so I just want to add that after the new hub was installed Sync3 1.0 displayed that the USB hub was not supported. However the hub still worked and allowed my USB device to load in the new software. Once the new software was installed the USB hub message didn't come back. Thanks again!!