marekrbk
Edge Member-
Posts
12 -
Joined
-
Last visited
-
Days Won
5
Content Type
Profiles
Forums
Gallery
Everything posted by marekrbk
-
iacc -Intelligent Adaptive Cruise Control
marekrbk replied to marekrbk's topic in 2017-2018 Edge & MKX
So, I was looking into the feature today; I have everything required enabled, but I still can't turn the function on. In the image, I’m using this specific configuration for the Lane Centering feature. If I change the settings, the system throws an error and the collision warning/prevention stops working. Essentially, to get IACC (Intelligent Adaptive Cruise Control) working properly, the ABS pump would need to be replaced with one from a facelift model—but there is a hardware compatibility issue there. It looks like the ABS pump needs to be replaced; the only issue I see is with the coding, as the software in the ABS unit does not include the PowerShift transmission. J1GC-2B373-EC -
I'm trying to get the IACC—Intelligent Adaptive Cruise Control For it to work, the requirements are an IMPA KT4T-19H406-C* The version starting before the last character must be c, the last one is irrelevant. and CCM module from 2020 or later, plus the necessary configuration. For proper operation, it is necessary to make a hardware change, as I described in the "lane centring" section. so, by replacing the CCM and IMPA modules and modifying their wiring IPMA,IPC,APIM It will be necessary to configure this hardware. I will add further findings.
-
I can send you a link to a site where you can download ETIS Offline; you can then run it using a virtual PC (VMware)—it has everything you need. Take a look at the site. I have it downloaded myself, but it’s 22 GB compressed, so I’m not sure where I could upload it. https://workshopmanuals.org/product/ford-mondeo-2014-2022-workshop-service-repair-manual-download/
-
HCM-K2GT-13C148-DD ist galaxy modul from 2020 C-CM -RADAR - JX7T-9G768-AC PSCM-K2GC-3F964-AF SCCM-KT4T-3F944-GAC GWM-L1GT-14F642-BC ist galaxy modul from 2020 IMPA--KT4T-19H406-CE Done🤝
- 1 reply
-
- 2
-
-
WACM – wireless charger. Connects to the HS3 bus and must be activated in the APIM. The installation method is improvised. Hardware: JX7T-19J235-BC
- 1 reply
-
- 2
-
-
I’ve started the retrofit: currently installing the CCM with its own bracket and the IPM-A with its own bracket; I’m swapping the SCCM for button compatibility and adding an HCM module from a Galaxy so the matrix headlights work—the bus wiring had to be changed as well. I still need to swap the PSCM, but I have to put that on hold since I’ll be away for three weeks. I’ll add the configuration and all the details—including the parts used and more detailed photos—after the replacement is done. -----------------The adaptive cruise control and lights are already working; for lane centering, I still need to replace the PSCM. Lane Centering for 2015–2018 models. Below is the list of hardware and settings that needed to be added/configured. Required configuration changes: IPC: Enable Traffic Jam Assist PCM: Cruise control with Stop & Go BCM: Cruise control with Stop & Go IMPA: TJA enabled SCCM: Left-hand stalk parameter set to 61 PSCM: Enable all extra features, including TJA ABS: Set "stop" value to 0
- 1 reply
-
- 3
-
-
It is located on the left side in the trunk. You just need to repin the power connection, because Sony wires the power differently. Sony power pin + 5,6 to 8,16 Bang & Olufsen Sony -negative cables from 13,14 to 5,13 Bang & Olufsen parts : KR3T-18T806-CJ B&O 900W Flash firmware
- 1 reply
-
- 1
-
-
I will try but I only have access to the schemes in Europe. It would be a good idea to check the connectors and their pinout in your vehicle and compare them; if the wiring matches, the only difference is the coding—meaning the As-Built data will differ, but the electrical setup will be the same. The Edge is manufactured in Canada, even for the European market.
-
-
https://mega.nz/file/GQdUwbyR#i2svtnMxx-E7DyLZ3a8g2ku-lTpcbupLIfpbH1UO6kM
-
DSM ****** need with ucds enable parameter Column Tilt capable and tele capable- Present Sccm *****Electric steering wheel Telescope + Tilt -Enabled Column coding must be started via forscan in the menu PATS Programming
-
https://mega.nz/file/iFlQgboB#1RjK20EqBEFdlMWAWtpjcgEFTiOiggZQ0Zs17icrn6o
