Jump to content

bigalx58

Edge Member
  • Posts

    33
  • Joined

  • Last visited

  • Days Won

    1

About bigalx58

bigalx58's Achievements

Newbie

Newbie (1/14)

  1. I have not experienced this on my 2010 Edge....it's got 39K miles.
  2. Yes...both of my bolts are capped with plastic covers.
  3. I have Sync Version Gen. 1-v3.1 installed on my vehicle. I did remove/install my cell battery and I was able to connect with an incoming call...perhaps I pushed the "phone" button on the steering wheel differently or it might have been a coincidence remains to be seen. Hopefully, it will continue to work. Thanks for your suggestions.
  4. I can remove/replace phone battery without any problems...but do I have to do the whole deleting/pairing routine for your second suggestion?
  5. I have a 2010 Edge. I haven't had any problems with the sync until a few days ago. While driving, my cell phone and the sync began to ring. I pressed the 'phone' button on the steering wheel like I have done in the past to connect, but the cell phone did not connect with the sender. I have to press the receive button on the cell phone in order to connect with the caller. I can send calls through sync by giving voiice commands without any problems. What can be done? Thanks.
  6. I think I have solved the mystery of the cruise cutting out. I like to drive with my hands at the bottom of the steering wheel.. The finger on my left hand must have touched the OFF button without me knowing it. It's very sensitive. On my last long trip, I did notice that I touched the OFF button... very slightly and the cruise went OFF!!!
  7. So, does this mean that it's acceptable? Is the back bumper hanging lower on the right side? If that's all it is then I won't be concerned. Thanks.
  8. Hopefully, I did what you suggested. I measured directly from top the tire, above, to the bottom of the wheelwell. Here are the measurements: RR.. 5 1/2 in LR..5 3/4 in...RF...8 1/4 in LF... 8 1/4 in. It would appear that the difference between the left and right sides is only 1/4 in and not 1 in. ...I would think that I wouldn't have noticed that.
  9. Measuring through the center of the wheels, I found the distances from the garage floor to the bottom of the wheel fenders to be as follows: Right front...33 1/2 in. Left front...33 5/8 in .... Right rear..33 in and Left rear..33 1/2 in. The distance from the bottom of the tailpipe to the floor is 12 in on the right side and 12 1/2 in on the left.
  10. I just noticed that my 2010 Edge is lower on the passenger side, looking from the rear, by about 1 inch. The car is parked in my garage. I'm using a line on the rear bumper as a reference point. I've got about 10K on the car. I do have some things stored in the spare tire area, fairly well distributed and I don't think that they would weight that much to drop the spring(?) by an inch. I guess I did notice this before, but didn't think anything of it until today. Should I be concerned about this or is it within accepted limits? I would hate to sit around at the dealers for a minor thing... Thanks.
  11. The cruise cut out again and I drove right to the dealer right away.. They found that I had problem code C 1963. They reprogrammed the ABS module. We'll see if that solved the problem.
  12. Aha...found the other push button and turned the headrests around...I agree, they are a bit too far back. Thanks.
  13. I find it uncomfortable to sit with the way the headrest is set up on my 2010 Edge. I've raised the headrest up as far as it will go and it's better now but not the most comfortable. I wonder if I take the headrest out and turn it around if that would be better, but I can't take the headrest out. I've tried pushing the tab in and pulling the headrest up, but it won't come off! Any suggestions? Thanks.
×
×
  • Create New...