Jump to content


Edge Member
  • Content Count

  • Joined

  • Last visited

About melgriffith

  • Rank
    New Member
  1. melgriffith

    2012 Edge SE heater not working

    Hi Yes, AC does blow cold air. For the heater (turning temp control knob to full heat) air does come out. Ran the heater for 30 mins during the commute home, no heat. Thanks
  2. melgriffith

    2012 Edge SE heater not working

    Hello I haven't used the heater since March. I used the heater today, it was a bit nippy after work, and the heater didn't work. I checked the fuse, tested the AC, everything looks good. Anyone know why the heater isn't working? Mel
  3. after you install, please provide some pics and installation steps. I'd like to install one in my edge.
  4. Thanks Candurin. Why I asked, I bought a pair of switchback from Ebay (http://www.ebay.com/itm/251343493088?item=251343493088&viewitem=&sspagename=ADME:X:AAQ:MOTORS:1123&vxp=mtr) and it stated it was standard wiring. I installed them and cannot get the white light to turn on, only the amber lights worked. I tested them separately, using a cordless drill battery pack and got both the white and amber lights to work. I should have just paid the money for the VLED lights. Mel
  5. Hi just wanted to verify when buying a switchback bulb, it should be 3157 CK wiring? please advise. Mel
  6. Hello has anyone tried these V-LED relays instead of the resistors?
  7. its a small crack in the middle of the mirror that didn't spread to the edge.
  8. Hello I accidently backed into my trash can and cracked the passenger side mirror. I know how to remove the side mirror assembly off the door. Does anyone here know how to remove the mirror? thanks, Mel
  9. Has anyone tried wiring the switchback to run as DRL for the white LEDs? any help is appreciated.
  10. I am requesting help. I have a 2012 SE Edge with 7500 miles. Today I was driving back from Mammoth and just reached a town called Adelanto, stopped off at the Circle K for bathroom break. I tried to start the engine and it didn't crank. I thought it was a dead battery and call AAA for a jump. The tow driver tried to jump the battery and engine didn't turn. checked all the fuses, connectors, nothing. horns work, parking light works, head lights work, radio works, all the gauges work. Only the vertical parking lights, Philips LED DRL, wasn't working. I again checked the fuses. I called road side assistance and Ford dealership and they instructed me to lock and unlock the car and turn the ingition again. nothing. I even tried the secret fob slot in the center storage. nothing work. the display doesnt show anything of "no key detected." I tried the shifter in park and neutral, nothing. I key does spin fully to ingition but just cant get the starter to sent juice to the engine. I finally got it towed to the Victorville dealership and I drove in a friends car to San Diego, 150 miles south of the Victorville Dealership. The sales guy there thinks its a bad fob. but the service department was closed so no one there to confirm. Does anyone here have or had this weird issue?
  11. I have a new white 2012 SE (white suede) and in the few weeks I had the car, I noticed that the bumper and body paint doesn't match. attached is the front bumper but the rear bumper is the same. Anyone here have or seen this type of issue before?
  12. I have an extra set of weathertechs (black) front driver and passsenger. I ordered a pair and my girlfriend ordered one too but I didn't know. So if your interested hit me up. $80 plus shipping, they are new if I didn't state it before. thanks, Mel
  13. melgriffith

    rattle / vibration

    did you have any issues of getting all the pins to sit completly in the door. I got tints window tints installed and the installer had to pull off the door panel to get the tints below the panel. But now I noticed that the top panel was loose, one of the corner panel pins wasn't fully inserted. I tried pushing the panel into the door but it doesn't lock in. I disassembled the door and checked each door pin and they all insert completely, just when I attach it to the panel, that last pin doesn't fully insert. any help is appreciated. thanks, Mel
  14. melgriffith

    2012 Door Removal/Speaker Install

    Hi Everyone: does anyone know how to install the panel back onto the friction clips (or pins). I just had tints installed on the front windows and noticed that both the driver and passenger side door panel was a little loose. As I investigated I could see that the top corner friction clip did not sit completely into the door hole. I even went to Napa to get a door trim tool to help push the friction clip but ended up scratching up the door paint. Any assistance is greatly appreciated. thanks, Mel
  15. I just bought a 2012 Ford Edge SE with the stock 17" painted rims. I wanted to upgrade to the 20" OEM rims. However just concerned with axle width and rear dif gearing. I was looking at the higher Edge models of limited, SEL, and sport, they have a wider axle, different gearing. And to add, don't know if suspension will be effected. Can or would someone here know if upgrading to 20" rims, I would also need to invest in upgrades to rear dif gearing, axle, and suspension. thanks Mel