GerryEdge

2022 Edge Titanium. One morning would start, but then stalled after about a minute -- in traffic!. Had towed to dealer. Diagnosis on my repair sheet reads: "FDRS_ U0109 & P025A. PPT KC. KC1-CK FOR CODES. KC2-CK Voltage to fuel pump control module -9.6. KC7-CK Power Circuit for Open- Pulled Fuel Pump Relay - Now Have Power." Well, I drove the car home (10 miles) - check engine light went on, and my app reported two errors - "An electrical fault with the fuel pump control module has occurred. This could result in a vehicle no start condition. The engine Start/stop feature may not be active when this fault is present." and "The powertrain control module lost communication with the fuel pump control module for a period of time. This alert may be accompanied with additional alerts and the vehicle may not start when the fault is present." Brought it back to dealer. The dealer said that Ford Engineering told them to replace "overlay wires". Dealer disagreed with Ford Engineering! They reset the Chek Engine light, drove it for 30 miles, and says it seems OK. Needless to say, without an explanation I don't have much faith that the car won't do this again. I am planning to bring to a different dealer, but in the meantime -- any thoughts out there? (I previously posted this in the 3.5L forum)

I have a 22 Edge Titanium -- 2400 miles on it. Last night when I tried to start it turned over and then stalled. Then it would not start. This morning it started, ran for about a minute, then stalled. I had it towed to the dealer and now I am waiting on their diagnosis. Anyone experience this with any other edge? Sensor, software, physical fuel pump problem?

I haven't noticed this on my 19 Titanium -- I purchased mine in mid-April -- have nearly 8000 miles on it. Not sure of the spec on my transmission though -- where is that into found?

I have a new 2019 Edge Titanium. Today on startup the information screen simply turned Blue, and was frozen on the Blue. The only display that showed was the backup camera as I backed out of the driveway, then as I put the car into drive, the screen turned to all blue. On a third restart, the system came back. Is this part of an update process, or did the system software have a glitch and then fixed itself? Thanks for any experience or explanations with this.