gary712

no it does not.that unit has to be wired in under the drivers dash

it is there. more green/tan than green/brown

peter, which alarm/rem start do u have? is it a ford unit or aftermarket? try to post a picture of the remote and I will try to help you

ford remote start on the edge is programmed for no tach to program key on foot on brake hold button till 3 beeps. foot off brake push button 1 time 4 beeps push button again 5 beeps now touch brake on n off 1 beep look at LED on harness push remote start fob 1 time n LED will go on. turn off key all done

Now thats a horse of a different color. 2010 edge reverse wire-green/brown drivers kic panel in harness going to rear of car

Ford remote start does that so that MY FORD KEY works. The car must see one of the ignition keys start the car for MY KEY to work. It can be programmed to be over-ridden.ask your dealer to do it

reverse light in 14 edge blue/white in driver kick panel pin #13 32 pin black plug

the steering wheel switch has to be changed for the sync to work. after that it has to be rewired to work correctly.

if this happens on AM and FM stations ck antenna

for tach wire use a wire from from one of the fuel injectors. pin 1 grn/blu gry/yel pur/gry yel/org brn or grn/wh

it sounds like the RS is programmed for tach. All the newer fords do not require a tach signal. I am not familar with the viper. Just go back into programming and set it for no tach or try voltage or hybrid or whatever they use that has a no tach setting.

it sounds like it is locked out. You will need the dealer IDS (computer)

depending on what year your edge is you can have the dvd play thru your radio system.from the audio out RCA jacks plug into the RCA jacks in your car or the 3.5 mm audio jack. switch the radio to entertainment or audio out

the radio is powered up by the can-bus.leave it where it is

sync