lildisco

Picked up some cabinets & tables from a neighboring high school auction. Doing truck stuffs

You don't need to pull the front bumper to replace the horn. I turned the wheel all the way one way (I believe passenger side) & unscrewed the fender liner screws & gives you access to the horn. I may have loosened an access panel in front of the wheel, but I don't remember. 

I purchased an OEM horn from a 15-18 edge & it was plug & play. Pretty easy actually. Probably 15 -  20 minutes total from start to finish. 

This guy removed the headlight to gain access, same principle. 

Currently sitting ~30.6 on my 2020 SEL. I'm assuming that it'll be ~28 manually calculated. 

27 minutes ago, Olwiseone said:

As far as wiring, when watching a few videos, the pros were using either Curt or the tenkonsha wiring harness. They look like they are plug and play. I will read more about forscan and see.

I can say that the Curt & other units like it aren't plug & play. You do have to wire to a power source, either the battery or the interior fuse panel with an add a fuse/quick fuse. They're not difficult to install, but definitely aren't plug & play. 

I used the Curt Class 3 hitch on my 2020 SEL AWD & the Curt T harness wiring. The only downside from the factory hitch is that the hitch sits 3-4 inches lower than the OEM one as it comes from under the bumper instead of through the bumper. The Curt Class 3 hitch probably took me ~2 hours to install by myself. Would have been less if I had help. I also installed Helper Springs to keep it level while towing. 

Definitely rides better while towing with the Helper springs installed. In the dual pic, the latest pic is the top pic

City driving / short trips kill my mpgs on my 2020 SEL AWD. Fuel quality & tire pressures play huge in these vehicles. Gas isn't the same, look for top tier fuel & I keep my tire pressures around 38psi in the front & 39psi in the rear. 

Bought this for ~$100 to see if it helps the sagging while towing. Did a run with a load in the hatch & didn't notice much of a difference, but I'll see what it does with the trailer in the next few weeks. 

Took the day off work to do truck stuff 

Welcome, looks like we're twins. I have 35% on the front with the factory tint on the back 

Test fit & run with Mockins cargo hauler bought last year. Used the anti-ratted clip unloaded & didn't hear anything after an hour drive. Maybe the weather will hold out & I can test it with a load. Supposedly can haul 600lbs, but don't plan hauling anywhere near that with this. I like that you can still access the hatch with it installed. 

I know the non sports/ST's are screw in style. 

OLM said 42% & I usually change it around 50%, so past due in my book. 

What do most people do before a snow storm? Plugs, oil change & drained the Catch Can usually isn't on the list, lol. Roughly about 3,000 miles since last oil change & plugs are original & had ~51,200 on them. Car has been tuned for over 20,000 miles. 

Not saying that it's your issue, but I heard a click on nearly every slow stop, like waiting in line a drive through, where the sound could echo off the wall, on our '16 SEL Fwd. After some digging, it turns out that the caliper pins & all points where the pads touch the caliper needed lubed. Bought some extra brake grease & haven't had a problem since.

Our calipers are painted & I think that the paint was causing the pad to stick to the caliper. I previously lubed them when I installed them, but it appears that it wore off or I didn't use enough. 

I also torque my lugs to ~110 ft/lbs & have never had an issue with rotor movement. Both our Edge's have Centric Premium Blank Rotors. The '16 SEL Fwd has PowerStop Z23 Evolution pads & the

2020 SEL AWD has Centric Premium ceramic pads. 

The wheel wells are made out of a hard felt type material & collect water. When  driving in the rain, they'll get their fill of water & gradually release some & evaporate some. All of the vehicles I've owned & garage will 'drain' after they've been driven in the rain. 

Both our 2016 & 2020 'drain' for awhile after their parked in the garage while it's been raining. It's a double edge sword. That material is also sound deadening & cuts down on road noise. If modified, it'll make driving down the road a little bit louder. Almost wish the wheel well was plastic with sound deadening material behind it. 

1 hour ago, Xtra said:

If anyone  was wondering how to obtain a V2 or V3 this is what to do. 
1. Join the forum, it is free. 
2. PM me by clicking on my name or avatar . Then click on the envelope icon. 

it is that easy .

Quess they're free! I'll take 4 ?

Or leave the doors open all night ?

Our 2020 wasn't in trickle mode when I went to bed, it somewhere between 75% to 100% after a couple of hours. I haven't checked it this morning, but I'm certain that it's in trickle mode. 

Our 2016 has a threaded part that goes around the terminal on the positive battery cable & should be plenty to thread the tiny ring connectors on. 

I've had 2 different types of chargers / tenders & usually leave the hood open when I have them hooked up & it's never been an issue.

I just hooked up our 2016 & it took ~4 hours to get to the trickle charge point. It got to 75% within 45 minutes. I just hooked up our 2020 to see if it'll get to the trickle charge point before I go to bed. 

They will do that to test how charged the battery is. I would use the ring connectors with the quick disconnect so that it'd make your life easier connecting & disconnecting. Our 2016 SEL Fwd 2.0 will say 75% on the Norco charger for a few hours, then go to trickle mode. 

Things are getting pretty serious around here... Class III 4,500lbs towing capacity (even though the edge is rated for 3,500lbs), 675lbs tongue weight, 2 inch receiver. Since an Exploder is too big for us to use on daily basis, this is a decent alternative for storage while traveling. Way over kill, but might tow a utility trailer from time to time. Also way cheaper to purchase through...... Home Depot at $180 with a $40 off PayPal coupon. Can't beat that! 

You're comparing apples to oranges when it comes to battery load. A '79 Econoline with barely any electronics & a 2001 Passat. Newer vehicles have way more tech than both of those previous vehicles combined. Even when the Edge is turned off, there's still plenty of things in the background running, like perimeter sensors for the passive alarm & keyless entry. The edge will eventually go into a deep sleep state, but there's almost always some electronics still on the vehicle at all times.

That's the great thing about the trickle chargers / maintainers, you simply hook it up to the battery without disconnecting anything (assuming that you have the quick connect/disconnect cables connected properly) & it automatically starts charging the battery to the point where it can maintain the charge. 

I would recommend plugging it in right after your last drive & it's going to sit awhile. You can also plug it after you're done driving for the day. I did that with my CX7 & the battery lasted ~8 years (had much less electronics than our Edge's). It comes down to which is more convenient for you. If you have remote start, it won't automatically start because the hood will be open. That may be an inconvenience for you, but shouldn't be a big deal 

If you're going with a trickle charger it doesn't really matter. The amps doesn't matter unless you're battery is close to being dead. It'll do a test to see how charged the battery is, then once it's charged it'll go down to like a floating charge & maintains the voltage for the battery. The bigger amperage one's will probably bring the battery up to proper voltage faster than a smaller amperage one, depending on how low it is. 

That's just one brand. Norco is another that's decent too. If you're uncertain, it doesn't hurt to go bigger than what you think that you need, just your wallet. I know that battery tender has been around for years & makes different styles of maintainers/tenders for numerous applications. You can see what best suits your needs. They have like a charging station if you have multiple batteries to charge, but it may be cheaper to buy 2 individual chargers/maintainers than 1 big charging station. The individual ones also come with their quick disconnects too so you shouldn't have to order anything extra. 

Don't know what brand of battery charger you use, but most battery tender / trickle chargers give to leads to go to the posts of the battery & give you a quick disconnect point so you can easily connect/disconnect. That depends on which you have or if you buy a new one. Battery tender is pretty good & I have several that I use. 

https://www.amazon.com/Battery-Tender-021-0123-Junior-Charger/dp/B000CITK8S

https://www.amazon.com/Deltran-Battery-Tender-Power-Plus/dp/B016S7NHWQ/ref=mp_s_a_1_5?c=ts&keywords=Battery+Chargers&qid=1640080781&refinements=p_89%3ABattery+Tender&s=automotive&sr=1-5&ts_id=15707061