ezndo

Added some leftover M3 quad exhaust tips I had in my garage. Outboard tips are for show and not connected to the exhaust pipe, only the inboard tips are connected. No room to use a traditional "Y" pipe with the stock muffler/pipe configuration.

Update: the bearing under the spring top hat was misaligned. Now that it is properly aligned and reinstalled, all is good.

Do you mean the 3 nuts that hold the strut in? If so, I checked them myself and they are tight, although I don't know what the proper torque spec is. Or the nut that holds the spring top hat?

A creaking noise more accurately describes it, definitely not clicking. The H &R springs didn't come with a new boot, so I assume the OEM boot was reused. Since the boot is rubber, I'm not sure it could cause a creaking sound when I turn the wheel.

2016 Sport. Springs installed yesterday and upon driving home heard this metallic sound from both front sides plus you can feel it in the steering wheel upon turning. Common? What to do? Plan on returning to installer next week but wanted your ideas first. Thanks for any suggestions.

Great write up! Like the ingenuity. Benefit may be small but has to be better than nothing.

That looks soooo much better Mine are flat black but I'm actually thinking of removing both bezels and replacing each bezel with 2 exhaust tips from my departed M3. Want the quad exhaust tip look. Just unsure of how to connect the 2 tips to the single OEM exhaust pipe on each side. Any ideas appreciated!

Thank you very much!

Ordered the springs from Vaccar, they have been delivered to my place in FL but I'm away for 2 more days. Any suggestions on where to do the installation? I usually do everything on my cars in NJ, but the Edge is at a condo in Pinellas County, FL and the association frowns on shade tree mechanics like myself.

Now yer talkin......I did mine with plastidip along with the "Edge" and "Sport" emblems. The gloss wrap should look great.

Too ricey for me but if you like them that's what matters

Mine looks the same as yours.....either we both are missing something or that's normal?

If true, 90% would be pretty, pretty good.

Yup, 2 valve system. I have zero miles with it installed, so it'll be awhile before I drain it. Car sits idle as I'm away a lot. I wish there was a way to tell how much it actually catches.....30%, 70%, 5%? Who knows? I installed a can on another NA car and it seems to work well but again, what percentage is it actually catching? Never seen an advertised amount probably because there is considerable blow by which would hurt sales.

Sorry for the crappy pics, will take better shots when I replace some of the clamps with shrink wrap. This is the generic kit from RX Speed Works. Tommy Thomsen answered all of my many questions concerning the install, given the provided instructions were not Edge specific. It took me a while to route the hoses under the engine cover as I wanted a clean install. I think I mounted the can in the only available vertical real estate, hope it works out OK.