22CarbGrayElite Posted Tuesday at 10:28 PM Report Share Posted Tuesday at 10:28 PM I finally got around to swapping the shelf panel on the dash for the actual storage cubby with lid that was used on the earlier 2nd gen Edges. My 2016 GMC Acadia had a similar dash cubby with a lid and I liked having that, so when I saw the older Edges had one, my OCD kicked in! Installation was a little time consuming but not difficult. I got this part from an online Ford parts website. 4 Quote Link to comment Share on other sites More sharing options...
bruker Posted Tuesday at 11:42 PM Report Share Posted Tuesday at 11:42 PM Nice! Do you have a part number for it? 1 Quote Link to comment Share on other sites More sharing options...
STBEAST Posted Wednesday at 04:12 AM Report Share Posted Wednesday at 04:12 AM Wow! That is so awesome. Could you give us any information about the whole 'upgrade'? I'm glad your OCD kicked in. I looks factory! 1 Quote Link to comment Share on other sites More sharing options...
Samurai Edge Posted Wednesday at 05:05 PM Report Share Posted Wednesday at 05:05 PM (edited) That looks really nice. As already asked, more info please. EDIT: Looks like this may the the part in question (?) https://www.ebay.com/p/2294518644 And this looks like the procedure to perform a swap: Edited Wednesday at 06:57 PM by Samurai Edge 1 Quote Link to comment Share on other sites More sharing options...
Wubster100 Posted 23 hours ago Report Share Posted 23 hours ago (edited) Did you notice a hidden logo inside the top center? Edited 23 hours ago by Wubster100 2 Quote Link to comment Share on other sites More sharing options...
22CarbGrayElite Posted 19 hours ago Author Report Share Posted 19 hours ago (edited) On 11/10/2026 at 5:42 PM, bruker said: Nice! Do you have a part number for it? ft4z58301a05aa On 11/10/2026 at 10:12 PM, STBEAST said: Wow! That is so awesome. Could you give us any information about the whole 'upgrade'? I'm glad your OCD kicked in. I looks factory! It is a little involved. The cubby itself snaps down into place with pressure clips, and it also bolts down in the front. The air vents have to come out along with the trim around the tip of the screen and I think you can get to them. I was tearing down the console and removing the screen to install the ANC bypass harness so I took care of the cubby while I was in there. On 11/11/2026 at 11:05 AM, Samurai Edge said: That looks really nice. As already asked, more info please. EDIT: Looks like this may the the part in question (?) https://www.ebay.com/p/2294518644 And this looks like the procedure to perform a swap: That is it, and it looks like it went up $40 since I bought mine a few weeks ago. It wasn’t a bad job, just time consuming and needing some patience. There are Ford PDF instructions on the forum here that were posted some time ago. 4 hours ago, Wubster100 said: Did you notice a hidden logo inside the top center? I don’t remember seeing it. I have to go back in there so I will look for it. Edited 19 hours ago by 22CarbGrayElite 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.