Comprehensive List of Possible Forscan Mods?

[gjkrisa]

i may have been thinking of horizontal wrong i thought that was up and down not left right. 

[gjkrisa]

i think its a wire today it says the alignment is 0.00 i did push one side off the post then checked the pid for alignment and it was 0 then was like lets see if it changes if i place it back and it did not without driving the vehicle. should i place this info in a different thread? 

[omar302]

On 8/20/2026 at 6:07 AM, gjkrisa said:

can any one help me figure out how to update the vin? top photo is new working c-cm from a mkx. second smaller photo is my oem c-cm module. my vin is 

2FMTK4AP3FBC40639

 

5LMTJ3DH5HUL21198 this is the mkx vin 

 

I have re-read your post and noticed that the VIN you posted for the vehicle if the new CCM is actually a Lincoln MKC, not MKX. The MKC is totally different, maybe the CCM is not compatible regardless of loaded software and calibration. 

[gjkrisa]

might be right as i can not find where it said the one i bought was the upgraded part. 

here is oem next to used mkc. they seem very close so i believe i had the right info. 

 

[gjkrisa]

ok searched EJ7T-9G768-AF on ford.com says only works for mkc  i do think this is reason. 

[Summers22]

Anyone know what to change to delete the all seatbelts pop up on the left side of the cluster on start-up?

[omar302]

1 hour ago, Summers22 said:

Anyone know what to change to delete the all seatbelts pop up on the left side of the cluster on start-up?

 

Maybe try the ABD configuration I had with the MKX cluster? Not sure if it would be the same or not. Check this post. 

[Summers22]

Thank you,  @omar302 do you know the value to disable the seatbelt location pop-up?

[omar302]

4 hours ago, Summers22 said:

Thank you,  @omar302 do you know the value to disable the seatbelt location pop-up?

 

It has been a few years, but I remember that with the values I posted I would not get the pop-up on startup, it would only pop up if a rear seat belt becomes unbuckled during the drive cycle. 

During startup, only a small grey "icon" (not a pop up) will show with the number of buckled seatbelts. 

[Summers22]

Thank you. So those values made it go away, I read it as uou added that feature, my mistake.

[omar302]

23 minutes ago, Summers22 said:

Thank you. So those values made it go away, I read it as uou added that feature, my mistake.

 

You are correct that I did add the feature. However, as I was playing around with the values, some values would make the pop up come up at startup (what you are facing right now), but the final values I kept don't have the pop up with only the grey icon showing and the pop up I'd a rear seatbelt is unbuckled.