gjb89

Thank you!

Decided I would try out the AFE dry flow panel filter. Seems to be pretty popular on the Fusion Sport Forums.

WELCOME!

Put the ac on low and set the fan to the highest speed and turn the recirculating off, then spray Lysol in the intake vents for the AC. It will knock it out real quick!

Has someone done this on the 15+ ?

Came out really good Nick

Check out post # 10 http://www.fordedgeforum.com/topic/20636-rear-emblem-paint/ It's hard to tell with the sun directly on the taillight but they are tinted the same shade as my headlights. The first time I changed the bulbs I didn't remove the headlights and it was a huge pain. After that I've taken the headlights off to replace the bulbs. FYI be care off the small little tabs that hold the bulb in. I broke a few of those off the first. Should change your DRL while you have the fixtures out. I was able to find one that matches the signature lights pretty close.

Just a little teaser. Testing out the logo prior to embroidering the headrests.

I'm running Osram CBI loving the slightly cooler temp. They do appear to be brighter.

This is what i"m using.

I use one of these vent mounts and i love it.

Here in Texas there are a lot of the electric spice edges sitting on lots. Never seen one on the road.

I stand corrected.

I'm loving LMS can't comment on which is better. There is someone on here who has had Unleashed first and then switched to LMS and hasn't gone back.

There should be 2. I know when one of them went out on my F150 they had to remove the whole dash to get to it...

Sounds like your blend door may be stuck.

Some kits that I have seen are very thick, with a lot of the buttons on the 15'+ edges being flush mounted I think it would look bad with the buttons recessed because of an overlay. To each their own. I will say the console trim on the Ford Edge is the easiest trim I have ever had to disassemble or assemble.

Was able to get these installed this weekend and wrap my taillights in lamin-x tint to match my headlights.

Here they are installed.

I used Lamin-x's lightest tint.

Vinyl wrap it. I'm sure you will save quite a bit going that route plus it won't look cheap!

Liquid Metal is my number 1 preset.

Well I used felt on pretty much every piece of plastic that makes contact with another piece of plastic on the center console. Rattles gone now.

Thank you!

I'm hearing a sloshing sound when driving, anyone know where the HVAC drain is?