johnmarkp Posted Saturday at 10:52 PM Report Share Posted Saturday at 10:52 PM Finally got the time to install the rotors and pads I got in June on my ST. Not that hard to do if you have the right tools. The 7mm and 11mm Allen sockets and the 18mm standard socket are not normally found in most tool sets you buy. A 1/2 inch impact wrench is also a good idea to have for the job. I can't find the thread here, but the idea to use a bolt through the holes for the anchor plate to remove the rotors is spot on. Both front rotors would not budge using a rubber mallet. I only had time to do the break in. So I cannot comment on how they function yet. The front pads had a lot of life left and the rotors were in pretty good shape. The rear pads were completely worn out and needed to be changed. I'll report back on how the brakes perform. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.